For indoor and outdoor decor, plants and gardening play a vital role. *The pictures help show how this works.Decorate your home and garden with your own creativity and crafting skills. Then, to adjust it higher you can turn the wire around the screw and back towards the front where you put the loop on the previous screw. This can be done again to adjust it even higher. If you move the loop back one screw with all four wires this adjusts the light up a few inches. By putting the loop on each screw this holds the light in place. Only two were drilled between the first and second hole on both sides and three were drilled between the second hole and the back. All the screws were drilled going towards the back. This is where the loop on the wire will go, so yours may be different.
Then, every three inches in the direction of the back of the stand we added a small screw but only screwed it in until there was about a quarter centimeter still above the wood. We measured the distance between the hooks on the light and drilled holes the same distance apart on the horizontal boards of the light holder.Ģ. The screws can be screwed in at a slight angle so that they are firmly in place. This is done on both sides and adds a lot of support that will be needed with there is heavy soil on the plywood. We then cut two boards at an angle on both ends so that they could be screwed into the leg and the newly added brace. This needs to be centered and screwed into the plywood.ĥ. Finally, we added another small brace on the bottom of the plywood on the back. Make sure to measure where you will put the beam so that it is as level as possible.Ĥ. We then added horizontal beams between the legs on the same side. *Our legs were a little wobbly, if this happens to you, you can sand the bottoms of the legs that are too long until the table is no longer wobbly.ģ. Make sure you measure the same distance from the ends on all four legs so that are even. Screw them into the side boards you attached to the plywood with two screws each. Next is the legs! These can be as tall or short as you would like.
0 kommentar(er)
